2301A and D
Load Sharing &
Speed Controls |
|
505/505E
Steam Turbine Controls |
3 days, $1170 per person
The 2301A and the 2301D Load Sharing and Speed Controls are successive generations of the same control. Learn the operation, installation and adjustments of these controls. The class will operate both controls connected to a closed loop test set. |
|
3 days, $1170 per person
Review 505/505E control theory and turbine parameters,
installation, wiring, operating procedures, programming
and troubleshooting. Program a 505 and operate
the control with a closed loop
test set. |
DSLC™
Control and MSLC Control
H |
|
EGCP-3
Engine Generator Control
|
|
3 days, $1170 per person
The basics of power management, DSLC™ &
MSLC controls including theory, installation, programming,
operation and maintenance plus hands-on programming, adjustments and troubleshooting
techniques. |
|
2 days, $780
per person
Learn about the EGCP-3. This class will
begin with an introduction to the basics of power management. The installation, programming, troubleshooting, and operation of the EGCP-3
will be covered and the class members will gain hands-on experience
in programming the control. |
Peak®
150 Control
H
|
|
GCP- 30 Series - Genset Control
|
2 days, $780
per person
Learn about the application, installation, and
operation of the Peak® 150 digital steam turbine controls used on steam turbines in mechanical drive applications.
Hardware and software will be explained, programming
demonstrated and the control connected to a closed loop test
set. |
|
2 days, $780 per person
The GCP-30 Series class will cover the GCP-31 and GCP-32. The class will cover the control, protection, monitoring, and
communication features of the GCP-30 Series. Applications
will be discussed. Class members will learn to apply,
install, program and adjust the GCP-30 Series of generator
control packages. |
| 723
PLUS and DSLC™/ MSLC Controls |
|
easYgen 3200 Power Management Control |
3 days, $1170
per person
Learn about the programmable digital 723PLUS
controls used with the DSLC™ and MSLC controls used
in power generation applications. Hardware and software will be explained
and programming demonstrated. |
|
2 days, $780 per person
Learn basics of power management using the easYgen 3200 control system. Class covers theory, installation, programming, operation and maintenance. Hands-on training will include programming, adjustments and troubleshooting techniques. |
723
PLUS Digital Speed Control
H |
|
|
3 days, $1170
per person
723PLUS control is a configurable control for prime movers. Both the hardware and software will be covered in class. During the course, programmig/monitoring with Woodward Watch Window will be done and a closed loop simulation will be available.
Note: You will need to bring your own PC installed with Watch Window and ServLink. |
|
|
