Clevis
DYNK-218-1 For use with 1/4-20 rod end bearings
DYNK-218-2 For use with #10/32 rod end bearings

Mounting/Installation Kits
DYNK-10206 General Purpose Kit for DYNA-8000 governor. No bracket in kit.
DYNK-10249 General Purpose Kit for DYNA-2000/2500 linear governor.
DYNK-10252 General Purpose Kit for DYNA 8400.
DYNK-10304 Cummins "B" Series, 4 & 6 cylinder, CAV-DPA pump, DYNA 2500
DYNK-10337 General Purpose Kit: Linear less MPU
DYNK-10350 Detroit Diesel 6, 8, 12V71 & 6, 8V92, using DYNA 8000 actuator
DYNK-10352 Detroit Diesel 8V149, 12V149 & 16V149, using DYNA 8400 actuator.
DYNK-10355 Detroit Diesel 16V71, 12V92 & 16V92, using DYNA 8200 actuator.
DYNK-10385 Deutz BFGM1012 & 1013
DYNK-10388 Zexel p-type fuel pump Direct on rack installation
DYNK-10393 Cummins "C" Bosch P3000 "A" pump
DYNK-10398 John Deere throttle lever tie down kit for 6101 & 6081
DYNK-10399 John Deere 6081 using DYNA 2500
DYNK-10400 Cummins "B" Bosch Inline P300 pump

Levers
DYNC-174 series
DYNC-182 series
DYNC-201 series
DYNC-208 series
DYNC-607 series
DYNZ-132 series

Magnetic Pickups
Magnetic Pickups are the communication link between your engine and our electronic governor control. The MPU is installed next to a drive shaft gear made of a material which reacts to a magnetic field. As each gear tooth passes the MPU, the gear interrupts the MPU's magnetic field and this produces an ac signal which corresponds to engine speed. This ac signal is wired into the magnetic pickup inputs on the controller.

SPECIFICATIONS
Thread Sizes: SAE (5/8 - 18 - UNF - 2A); SAE (3/4 - 16); Metric = (M - 16 x 1.5 g)
Insertion Depth: Various lengths
Connection: Open leads - MS connectors

DYNT-10XXX series
DYNT-11XXX series
DYNT-13XXX series
DYNT-15XXX series
DYNT-17XXX series
DYNT-19XXX series